Free Circuit Diagram

Stepper motor controller is needed to run a stepper motor, since a stepper motor cannot work by just connecting it to a power supply.  To program a stepper motor to make a complex movement, we usually need a micro controller. Fortunatelly, for a simple movement like just rotating eith a constant speed, we can use [...]

This testing instrument provide two alternate fuction: signal injector and signal tracer.  This audio signal tracer/injector is very helpful in trouble shooting audio circuits, when you need to test a circuit by injecting a signal and observe the output (by watching the oscilloscope or by hearing the loudspeaker for example), or by tracing some points [...]

UHF antenna booster can be used for better reception, especially when you’re far from TV station / relay transmitter. This UHF antenna booster works in 400-850 MHz range. Here is the circuit diagram of the UHF antenna booster:

The circuit use only one transistor, but it gives you 10 to 15 dB amplification, enough for many [...]

LED flasher circuit here will flash a LED using only 1.5 volts  supply voltage. Normally, to make any LED lamp works, you need more than 2 volts power supply. This because LED will work only when the supply voltage is higher than its forward bias voltage, around 2 volts  for red LED, and slightly lower [...]

This FM transmitter circuit is small, similar to our previous single chip FM  transmitter, but this FM transmitter is monophonic. You can see in the circuit’s schematic, the left and right signals is mixed before modulate the radio frequency. Here is the schematic diagram of the circuit:

 
The core of this FM transmitter circuit is a [...]

This antenna booster circuit can be used to amplify the weak signal received by the antenna.  Antenna for AM/FM is usually not tuned for the optimal dimension of 1/4 wavelength, since we prefer small portable size. This untuned antenna has very low gain, so the antenna booster circuit here is very helpful in getting better [...]