Free Circuit Diagram

RJ45 is used to connect Ethernet port on your computer. There are two configuration: straight and cross. Straight RJ45 cables should be used to connect between computer and device such as switch or hub, and cross RJ45 cables should be used in computer-to-computer connection.  Some hub or switch has the capability to detect the cable [...]

This pin diagram will be  useful when viewing these connectors. Sometimes you hold a soldering iron to the back of the connector, and you don’t remember the numbering of the pin. Here is the pin diagram for your reference:

The number of each pins are actually  stamped on both sides of any D-type connector. Unfortunately, since [...]

A LED flasher circuit can be built using only one transistor and few passive components. This circuit is a proof of Negative Resistance (the Esaki or Tunnel Diode in from 1957) The Transistor is coupled / Biased in the Opposite polarity.

[Video tutorial source: youtube.com]

In this video tutorial,  you can learn how to make a LED flasher circuit using 555 IC. The project uses a breadboard, so you don’t need any soldering work. A good start for do it yourself  (DIY) project.

[Video tutorial source: Youtube.Com]

How to solder a resistor to PCB is presented in this video tutorial, get expert tips and advice from an expert on how to solder electronic equipment in this free instructional video. Expert: Jeff Nayl…

Silicon pezoresitive-bridge pressure transducer (SPPT) is very popular in medical, industrial, environmental, and automotive pressure sensor application. The general architecture of SPPT uses a thin micromachined silicon diaphragm incorporates a implanted piezoresitive Wheatson-bridge strain-gauge.
The transducer design allows only a small diaphragm deflection sin it has limited elasticity, and this produces only a very small output [...]