Free electronic circuit design and schematic diagram
Because the differential input capability of the AD532, algebraic solution of several interesting functions such as difference of squares, (X2-Y2)/10V is allowed. The following figure shows us about the configuration of AD532 in the square mode, with a simple unity gain inverter connected between one of the signal inputs (Y) and one of the inverting input terminals (-Yin) of the […]
Read more
For convenient reading, the display of this tachometer circuit show inthe reading in hertz directly. The conversion time will be equal to the gating time, which is 0.1 second with pin 11 of the ICM7027A connected to Vdd, make the display show tens of hertz at the least significant digit. An ICM7207 can be used with a 6.5536 MHz crystal […]
Read more
Common mode rejection ratio (CMMR) is one parameter that specify the instrumentation performance. LM4250 is high performance op-amp which is characterized by very low power consumption. With special arrangement as shown in the following schematic diagram, the instrumentation amplifier circuit will be featured with calibration to maximize the CMMR performance.
Read more
The following schematic diagram shows us about the connections for square root mode for ADS532 analog processor chip. Similar to the division mode, the multiplier cell is connected in the feedback of the op amp by connecting the output back to both the X and Y inputs. To prevent latch up as Zi approaches 0 Volts, the diode D1 is […]
Read more
For mono output amplifier application, TDA7056 IC can be your option. Compact but powerful, this integrated circuit is contained in a 9 pin medium power package. This device is designed for battery fed portable equipments such as mono recorders, radios and television. To attract the market, TDA7056 has many features such as low power consumption. For more reliable operation, TDA7056 […]
Read more
Using the phase sensitive detector circuit below the magnitude of sinusoidal signal can be measured. Beside that, this circuit also can be used to measures 180°-out-of-phase inputs with proper polarity. But, it depends on the relationship to the reference with less than 1% error. This circuit uses a AD741J op amp. Here is the schematic diagram of the circuit and […]
Read more