Free Circuit Diagram

This is an application that can be used to adjust LED brightness while maintaining superior color quality. This application uses pulse width modulation (PWM) dimming technique. This application can be used for single-line scrolling displays, transportation road signs, simple scoreboards, ever-expanding advertising markets encompassing convenience gas stations, shops, stadiums, and stores. Following figures shows color [...]

The TPS61160/1 is a boost converter that drives up to 10 LEDs in series with a 40-V rated integrated switch FET. To reduce output ripple, improve convertion efficiency, and allows for the use of small external component, the boost converter is very usefull. The default white LED current is set with the external sensor resistor [...]

Light dimmer circuit is used to control the lamp for arbitrary brightness. This dimmer circuit work for incandescent lamp, not a fluorescent one.  The dimmer circuit here work for both 110V and 220V AC.  Here is the schematic diagram of the circuit: /caption] Dimmer Wiring Diagram The dimmer circuit is [...]

Autoranging is useful to extend the measurement range of an available ADC (analog-to-digital converter).  Autoranging will best implemented for multiplexed input.  LTC1257 is appropriate for system autoranging, adjusting an ADC’s full-scale range. During the conversion process, U2 and U3 receive the full and zero scale codes, respectively, that correspond to a [...]

A phase control circuit can be used to control the power delivered to an AC load. The phase control circuit control the AC waveform, cutting the cycle to give full cycle, half cycle, zero cycle, or somewhere in between. You can say this circuit is similar to a dimmer circuit, but the switching is synchronized [...]

Integration is one of basic signal processing that can be done in analog domain. Using operational amplifier (op-amp), integration operation can be done with very simple circuit with very high accuracy. Here is the schematic diagram of an integrator circuit: The resistor R2 should have the same value with R1 since R2 [...]