Free Circuit Diagram

This PWM  circuit needs only two inverter gates, so you can build up to 3 independent PWM circuit using only one IC chip, since there are at keast 6 inverter gates in one IC package. Here is the schematic diagram of the circuit: Please remember that you should connect any input pins of [...]

For you who has failed to build  radio transmitters, this circuit worth a try. This circuit uses 74HC14 hex Schmidt trigger as the oscillator, and you can choose to use capacitor for low cost goal or quartz  crystal for better stability. For quartz crystal, you can choose any frequency between 00.7-1.6MHz, but around 1.6MHz is [...]

Water level controller circuit described here control the water level inside a tank. There two modes available with this water level controller circuit. The first mode is empty mode, when the controller will drain the tank if the water level reach the upper limit, the pump will be used to suck the water from the [...]

This is a FM Transmitter circuit. This circuit uses logic gates. This transmitter circuit has a RF oscillator. This oscillator uses 10.7Mhz ceramic filter and inverter N2 to drive the parallel combination of N4 to N6 through N3. Here is the circuit: The output impedance will be low because these inverters are [...]

Electrolysis process has been the primary cause of your water level detector probes, and you can avoid this by sensing the current by this probe using alternating current. In alternating current, the electrolysis process will be reversed for every alternating cycles, making the probe will last longer to survive from corrosion. The electronic circuit for [...]

We  can make a simple touch switch using only two inverter gates, two resistors, and two capacitors. The schematic diagram of the circuit is shown in the figure below. At power up, the output (of U1A) will be high, and the inverting output will be low because U1A gate will be triggered to ground level [...]