Free Circuit Diagram

A DC-to-DC step-up converter is traditionally implemented using transformer, working by converting the DC voltage to AC Voltage, step-up it using transformer, then rectify and filter the transformer’s output to  get a higher DC voltage. Using a switching method, we can step-up a voltage without a transformer. We just need an inductor which is driven [...]

Using this switch mode regulator circuit, you can get a stable 12 volt output (500mA) although you just have 4,3 – 10V power supply. You can even boost a 3.5V input to 12V if the load draws only 100 mA or less. This switch mode voltage regulator use LTC1266 IC chip from Linear Technology. Here [...]

A phase control circuit can be used to control the power delivered to an AC load. The phase control circuit control the AC waveform, cutting the cycle to give full cycle, half cycle, zero cycle, or somewhere in between. You can say this circuit is similar to a dimmer circuit, but the switching is synchronized [...]

Light dimmer circuit is used to control the lamp for arbitrary brightness. This dimmer circuit work for incandescent lamp, not a fluorescent one.  The dimmer circuit here work for both 110V and 220V AC.  Here is the schematic diagram of the circuit: /caption] Dimmer Wiring Diagram The dimmer circuit is [...]

Fluorescent lamp or tube lamp (TL) has good efficiency. This high efficiency feature make it suitable for battery operated lighting application. To drive the tube lamp, we need high voltage to make the gas inside the tube get ionized. Here is the schematic diagram of the fluorescent lamp circuit: To trigger the ionizing [...]

Autoranging is useful to extend the measurement range of an available ADC (analog-to-digital converter).  Autoranging will best implemented for multiplexed input.  LTC1257 is appropriate for system autoranging, adjusting an ADC’s full-scale range. During the conversion process, U2 and U3 receive the full and zero scale codes, respectively, that correspond to a [...]