Free Circuit Diagram

This current sensing circuit sense the current at the high side (between positive supply and load). This circuit take the benefit of the microampere supply current and Rail-to-Rail input of the LT1494 op-amp. Here is the schematic diagram of the circuit: Look at the op-amp, the inverting input is connected directly to the [...]

A LT1637 is advertised as 1.1MHz, 0.4V/us Over-The-Top Micropower, Rail-To-Rail Input and Output Op Amp. This features are suitable for current sensing application since input voltages are right at the upper rail. The circuit show current sensing of 5V supply system, but  monitoring up to 44V application can be done by this circuit  (the maximum [...]

High voltage current sensing/monitoring can be designed using LTC6101 op-amp. The following current sensing circuit is capable of measuring electrical current in 500 volts system. Here is the schematic diagram of the circuit: Two external Mosfets is added to hold off the voltage, allows the LTC6101 to be connected to a very high [...]

This circuit provide automatic current limiting up to 8.4A. Unlike current limiter that uses only a resistor, this current limiting circuit doesn’t drop the voltage, or at least keep the voltage drop at minimum, until a certain current amount is exceeded. This current amount limit is adjustable from 1.4 A to 8.4A using a [...]

This is a simple circuit that can be used to convert a 4-20mA signal to a 0V to 5V analog voltage. It is ideal conversion to digital with an analog-to-digital converter (ADC). In this circuit, a current-sense amplifier (IC1) is used to monitor the loop current. To generate a ground-referenced output that ranges from 0V [...]

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]