Free Circuit Diagram

Precision accelerometers needs inverting mode amplifier since they are usually charge-output  devices. This amplifier convert charges into voltage output. The circuit below is an example of accelerometer with DC servo. The charge from the transducer is converted to a voltage by C1, which should equal the transducer capacitance plus the input capacitance of [...]

Current amplifier application need very low input bias current, and CA3140 is one of suitable op-amps for this purpose. The circuit’s schematic diagram is shown in the figure below. In the circuit, low current is supplied at the input potential as the power supply to load resistor RL. When the load current is [...]

This a a simple circuit for precision current sink. This circuit uses two kinds of transistor, 2N2219 bipolar transistor and 2N3069 JFET because both of them have inherently high output impedance. Here is the circuit : To provide feedback to the LM101 op amp, this circuit uses R1 as a current sensing resistor. [...]

On the circuit diagram, R1 is used to senses current flow of a power supply. We could use JFET as a buffer because Id=Is, therefore the power supply current flow is accurately reflected by the output monitor. Here’s the circuit diagram: [Source: National Semiconductor Application Note]

High voltage current sensing/monitoring can be designed using LTC6101 op-amp. The following current sensing circuit is capable of measuring electrical current in 500 volts system. Here is the schematic diagram of the circuit: Two external Mosfets is added to hold off the voltage, allows the LTC6101 to be connected to a very high [...]

This current sensing circuit sense the current at the high side (between positive supply and load). This circuit take the benefit of the microampere supply current and Rail-to-Rail input of the LT1494 op-amp. Here is the schematic diagram of the circuit: Look at the op-amp, the inverting input is connected directly to the [...]