Free Circuit Diagram

For any electrically conductive liquid level measurement, this single chip circuit is very compact and simple. This circuit is an ac excited fluid level sensor, which uses alternating current to provide biasing for the sensor probe to avoid electrolysis of the probes.  This ac excitation makes the sensing probe has longer lifetime. This circuit can [...]

Water level controller circuit described here control the water level inside a tank. There two modes available with this water level controller circuit. The first mode is empty mode, when the controller will drain the tank if the water level reach the upper limit, the pump will be used to suck the water from the [...]

For the best advantage as a low noise high input impedance device, the preamp and tone control uses JFET. If the circuit reaches harmonic distortion levels of less than 0.05% with a S/N ratio of over 85 dB, all device parameters are non-critical. 18 dB of cut and boost is allowed by the tone controls. [...]

This circuit is similar to our previous tone control circuit, a bass-treble tone control circuit, but here we present the formula for design your tone control’s custom frequency response. Here is the schematic diagram and formula of the tone control circuit: Almost all op-amp type can be used, as long as they have [...]

This LED (Light Emitiing Diode) display consist of 10 LEDs to indicate the level of an input signal. If the signal is small, only LED#1 will light, and if the signal level getting higher then you’ll se the light dot will move through LED #2, #3, #4, … and so on. When the signal input [...]

Electrolysis process has been the primary cause of your water level detector probes, and you can avoid this by sensing the current by this probe using alternating current. In alternating current, the electrolysis process will be reversed for every alternating cycles, making the probe will last longer to survive from corrosion. The electronic circuit for [...]