
Many new computers now only has USB port, and this serial to USB adapter might be the only help for old devices that provides only RS232/COM Port. This serial adapter uses FT232 USB-RS232 converter IC from FTDI (Future Technology Devices International). The main features of this USB serial adapter chip are: 384 [...]
Read the rest of this article [..]

Notch filter is known as band-cut filter or band-reject filter. The fuction of this filter is to remove some frequency portion of a signal. The schematic diagram of this filter circuit, a second order notch filter is depicted in the figure below. The formula is actually complicated, but by taking the R3=R4 and [...]
Read the rest of this article [..]

Using MAX232 integrated circuit, you can build a TTL-to-RS232 level converter that totally comply with RS232 electrical specification. The IC generate the higher positive and negative voltage (+10 and -10 Volts) from TTL power supply (5V DC) using switched capacitor. The switching circuitry is provided inside the chip, so you need only few caps for [...]
Read the rest of this article [..]

Using a single supply quad comparator LM339, LM239, LM2901, LM2901V, NCV2901, or MC3302, we can build a square-wave oscillator with simple circuit and formula. Here is the schematic diagram: This circuit is suitable if you need many square-wave oscillators in one circuit, since the quad packaged comparator provide four comparators in one single [...]
Read the rest of this article [..]

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]
Read the rest of this article [..]

The simple low-pass filter is shown in Figure below. The filter has a 20dB/decade roll-off after its corner frequency fc. Its low-pass frequency gain (f->0) is defined by R3/R1. This allows low-frequency gains other than unity to be obtained. R2 should be chosen equal to the parallel combination of R1 and R3 to minimize error [...]
Read the rest of this article [..]