Mosfet Tester
This circuit included in the category astable multivibrator. This circuit is used to test N-Mosfets (the power kind e.g irf830), whether it works or not. If it is not working, the LED will not flash. If Mosfet is working it will operate in the astable multivibrator circuit causing the Led to flash. Here is the [...]
Read the rest of this article [..]
Simple Touch Switch Using 555 IC
This 555 circuit will activate a buzzer and turn on a LED lamp when you touch the probe. Here is the circuit’s schematic diagram: lf you touch the plates, the lamp and the buzzer will be activated for a predetermined time period. The time period is determined by 100k resistor and the 10uF [...]
Read the rest of this article [..]
Simple Toggle Touch Switch Using Two Inverter Gates
We can make a simple touch switch using only two inverter gates, two resistors, and two capacitors. The schematic diagram of the circuit is shown in the figure below. At power up, the output (of U1A) will be high, and the inverting output will be low because U1A gate will be triggered to ground level [...]
Read the rest of this article [..]
Very Simple Touch Switch Using 4050 CMOS Buffer
Many efforts has been made to make simpler circuit, and here is one result, a very simple touch switch. You can build up to 6 similar circuit using only one 4050 chip. If you touch the “on” pad, the output will be on on remains on until you or some one the “off” pad. Here [...]
Read the rest of this article [..]
Dimmer Circuit
Light dimmer circuit is used to control the lamp for arbitrary brightness. This dimmer circuit work for incandescent lamp, not a fluorescent one. The dimmer circuit here work for both 110V and 220V AC. Here is the schematic diagram of the circuit: /caption] Dimmer Wiring Diagram The dimmer circuit is [...]
Read the rest of this article [..]
| 
