
This is a protocol translator circuit. This circuit uses the MAX3162, it contains both RS-485 and RS-232 transmitters and receivers. This IC contains wide range of communication devices, that can convert bidirectionally between RS-485 and RS-232 signals. Here is the circuit : The upper circuit is the translator for point to point [...]
Read the rest of this article [..]

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]
Read the rest of this article [..]

Using a single supply quad comparator LM339, LM239, LM2901, LM2901V, NCV2901, or MC3302, we can build a square-wave oscillator with simple circuit and formula. Here is the schematic diagram: This circuit is suitable if you need many square-wave oscillators in one circuit, since the quad packaged comparator provide four comparators in one single [...]
Read the rest of this article [..]

This circuit is similar to our previous tone control circuit, a bass-treble tone control circuit, but here we present the formula for design your tone control’s custom frequency response. Here is the schematic diagram and formula of the tone control circuit: Almost all op-amp type can be used, as long as they have [...]
Read the rest of this article [..]

The simple low-pass filter is shown in Figure below. The filter has a 20dB/decade roll-off after its corner frequency fc. Its low-pass frequency gain (f->0) is defined by R3/R1. This allows low-frequency gains other than unity to be obtained. R2 should be chosen equal to the parallel combination of R1 and R3 to minimize error [...]
Read the rest of this article [..]

RJ45 is used to connect Ethernet port on your computer. There are two configuration: straight and cross. Straight RJ45 cables should be used to connect between computer and device such as switch or hub, and cross RJ45 cables should be used in computer-to-computer connection. Some hub or switch has the capability to detect the cable [...]
Read the rest of this article [..]