Free Circuit Diagram

This is a protocol translator circuit. This circuit uses the MAX3162, it contains both  RS-485 and RS-232 transmitters  and receivers. This IC contains wide range of communication devices, that can convert bidirectionally between RS-485 and RS-232 signals. Here is the circuit : The upper circuit is the translator for point to point [...]

Light dimmer circuit is used to control the lamp for arbitrary brightness. This dimmer circuit work for incandescent lamp, not a fluorescent one.  The dimmer circuit here work for both 110V and 220V AC.  Here is the schematic diagram of the circuit: /caption] Dimmer Wiring Diagram The dimmer circuit is [...]

Autoranging is useful to extend the measurement range of an available ADC (analog-to-digital converter).  Autoranging will best implemented for multiplexed input.  LTC1257 is appropriate for system autoranging, adjusting an ADC’s full-scale range. During the conversion process, U2 and U3 receive the full and zero scale codes, respectively, that correspond to a [...]

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]

A phase control circuit can be used to control the power delivered to an AC load. The phase control circuit control the AC waveform, cutting the cycle to give full cycle, half cycle, zero cycle, or somewhere in between. You can say this circuit is similar to a dimmer circuit, but the switching is synchronized [...]

Integration is one of basic signal processing that can be done in analog domain. Using operational amplifier (op-amp), integration operation can be done with very simple circuit with very high accuracy. Here is the schematic diagram of an integrator circuit: The resistor R2 should have the same value with R1 since R2 [...]