FreeCircuitDiagram Articles Search
Custom Search



1st-order-3-Way Crossover Circuit Design Using Free Online Tool

circuit schematic

Designing passive crossover network for your speaker system is easy, just like what shown in our previous crossover design article, but now we can design many types of crossover even easier using online crossover design tool. The crossover schematic diagram here is an example  with a case of 10 kHz high corner frequency, 1250 Hz  [...]



Read the rest of this article [..]

Square Oscillator Using Comparator: The Circuit Schematic Diagram and The Formula

circuit schematic

Using a single supply quad comparator LM339, LM239, LM2901, LM2901V, NCV2901, or MC3302, we can build a square-wave oscillator with simple circuit and formula. Here is the schematic diagram: This circuit is suitable if you need  many square-wave oscillators in one circuit, since the quad packaged comparator provide four comparators in one single  [...]



Read the rest of this article [..]

Wien Bridge Oscillator: The Circuit Schematic Diagram and The Design Formula

circuit schematic

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]



Read the rest of this article [..]

Baxandall Tone Control Using LM833: The Circuit’s Schematic Diagram and The Formula

circuit schematic

This circuit is similar to our previous tone control circuit, a bass-treble tone control circuit, but here we present the formula for design your tone control’s custom frequency response. Here is the schematic diagram and formula of the tone control circuit: Almost all op-amp type can be used, as long as they have [...]



Read the rest of this article [..]

First Order Low-Pass Active Filter: The Circuit Schematic Diagram and The Design Formula

circuit schematic

The simple low-pass filter is shown in Figure below. The filter has a 20dB/decade roll-off after its corner frequency fc. Its low-pass frequency gain (f->0) is defined by R3/R1. This allows low-frequency gains other than unity to be obtained.  R2 should be chosen equal to the parallel combination of R1 and R3 to minimize error [...]



Read the rest of this article [..]

RJ45 Port Pinout

circuit schematic

RJ45 is used to connect Ethernet port on your computer. There are two configuration: straight and cross. Straight RJ45 cables should be used to connect between computer and device such as switch or hub, and cross RJ45 cables should be used in computer-to-computer connection.  Some hub or switch has the capability to detect the cable [...]



Read the rest of this article [..]




 Page 1 of 37  1  2  3  4  5 » ...  Last »