FreeCircuitDiagram Articles Search
Custom Search



Phase Control Circuit

circuit schematic

A phase control circuit can be used to control the power delivered to an AC load. The phase control circuit control the AC waveform, cutting the cycle to give full cycle, half cycle, zero cycle, or somewhere in between. You can say this circuit is similar to a dimmer circuit, but the switching is synchronized [...]



Read the rest of this article [..]

3 Phase AC Motor Speed Control

circuit schematic

Controlling the speed of three phase ac motor is done by controlling the frequency of the power line supply,  since the motor is synchronized with the line frequency. Three phase ac motor speed controller is actually nothing more than three phase sine wave power inverter with variable frequency. The three phase power inverter is a [...]



Read the rest of this article [..]

Slave Flash Light Control Using Only Three Components

circuit schematic

You can use this circuit to give auto trigger for your secondary flash light. You don’t have to worry about wiring for the control, because using this circuit your secondary flash will be automati8cally triggered when it receive the light signal from the primary flash. Look at the circuit’s schematic diagram below. The [...]



Read the rest of this article [..]

Three Op-Amps Instrumentation Amplifier: Easy Gain Adjustment Design

circuit schematic

Although this circuit use more resistor components than in basic standard three op-amps instrumentation amplifier circuit, this circuit has the benefit of easy gain adjustment with only one control resistor. Because the easy gain adjustment feature, this circuit topology has been used inside a single chip instrumentation amplifier ic. The figure below shows the schematic [...]



Read the rest of this article [..]

Three Op-Amps Instrumentation Amplifier

circuit schematic

Using LMV721/722 or any other high impedance op-amps, you can build an instrumentation amplifier using standard three op-amps instrumentation amplifier circuit. The figure below shows the circuit’s schematic diagram. The final stage of this instrumentation amplifier is a differential-input, differential-output amplifier, with two voltage followers feed its inputs. These two voltage followers assure [...]



Read the rest of this article [..]

Split-Phase Data Synchronization and Decoding

circuit schematic

A split-phase data signal consists of a series of binary digits that occur at a periodic rate, as shown in waveform A in the timing chart. The weight of each bit, 0 or 1, is random, but the duration of each bit and, therefore, the periodic bit rate, essentially is constant. A [...]



Read the rest of this article [..]




 Page 1 of 20  1  2  3  4  5 » ...  Last »