Free Circuit Diagram

We  can make a simple touch switch using only two inverter gates, two resistors, and two capacitors. The schematic diagram of the circuit is shown in the figure below. At power up, the output (of U1A) will be high, and the inverting output will be low because U1A gate will be triggered to ground level [...]

You can use a humidity sensor to give an alert of boat leakage, or when your books start being flooded by heavy rain attack on your broken roof, or anything you can imagine. A simple humidity sensor (a humidity probe) can be constructed using two copper wires placed as close as possible to each other, [...]

This 555 circuit will activate a buzzer and turn on a LED lamp when you touch the probe. Here is the circuit’s schematic diagram: lf you touch the plates, the lamp and the buzzer will be activated for a predetermined time period. The time period is determined by 100k resistor and the 10uF [...]

Introduction Interfacing humidity sensor can be difficult because of the sensor’s drive requirement and their wide dynamic range.  We can customize the circuit to obtain reasonable accuracy within the chosen range by carefully selecting the devices that comprise the analog front end. Here  we present a case study to design analog signal conditioner for [...]

Many efforts has been made to make simpler circuit, and here is one result, a very simple touch switch.  You can build up to 6 similar circuit using only one 4050 chip. If you touch the “on” pad, the output will be on on remains on until you or some one the “off” pad. Here [...]

In some temperature-sensing applications there are some problems caused by the placement of sensors on location where the potential is very different from that of the data-acquisition-system common. So the operating temperature sensor must be isolated from its data-acquisition system galvanically.  And the power’s source for the sensor was isolated. This circuit is designed to [...]