
We can make a simple touch switch using only two inverter gates, two resistors, and two capacitors. The schematic diagram of the circuit is shown in the figure below. At power up, the output (of U1A) will be high, and the inverting output will be low because U1A gate will be triggered to ground level [...]
Read the rest of this article [..]

This circuit included in the category astable multivibrator. This circuit is used to test N-Mosfets (the power kind e.g irf830), whether it works or not. If it is not working, the LED will not flash. If Mosfet is working it will operate in the astable multivibrator circuit causing the Led to flash. Here is the [...]
Read the rest of this article [..]

For standard instrumentation amplifier, a three op-amps instrumentation amplifier circuit is common, but if you need smaller component count and lower cost, you can use just two op-amps for the same function: a high impedance and good CMRR for sensor pre-amplification and buffering. Here is the circuit’s schematic duiagram: A two-op-amp instrumentation amplifier [...]
Read the rest of this article [..]

To produce a pre-amplifier with accurate RIAA response, this circuit use two stages of amplifier. This circuit is more complex than single op-amp RIAA pre-amp, but the performance is excellent in terms of accurate frequency response. Here is the schematic diagram of the circuit. The circuit uses LM833 high performance op-amp from National [...]
Read the rest of this article [..]

Please be warned if operating this circuit might violate the regulation of your country, because this FM transmitter circuit radiate strong radio frequency to the environment. This wireless microphone is very sensitive, pick up every sound in the 20m radius, and transmit the radio signal up to 2 kilometers in open air. Here is the [...]
Read the rest of this article [..]

This tone control circuit use very popular Baxandall configuration, a simple circuit configuration that provides boost and cut control in continuous manner. This circuit is very cheap to build, and it’s commonly implemented in commercial product. Here is the circuit’s schematic diagram: The transistors can be substituted by any general audio transistors with [...]
Read the rest of this article [..]