
This is pressure sensor signal conditioning circuit. It is simple and inexpensive circuit because it has small geometry and simple pressure sensor. It just uses a single Operational Amplifier. This circuit obtain power from from 3-V battery. To work properly this circuit must work in 0 C to 50 C temperature range. Here is the [...]
Read the rest of this article [..]

For any electrically conductive liquid level measurement, this single chip circuit is very compact and simple. This circuit is an ac excited fluid level sensor, which uses alternating current to provide biasing for the sensor probe to avoid electrolysis of the probes. This ac excitation makes the sensing probe has longer lifetime. This circuit can [...]
Read the rest of this article [..]

Introduction Interfacing humidity sensor can be difficult because of the sensor’s drive requirement and their wide dynamic range. We can customize the circuit to obtain reasonable accuracy within the chosen range by carefully selecting the devices that comprise the analog front end. Here we present a case study to design analog signal conditioner for [...]
Read the rest of this article [..]

To obtain an accurate pressure value, we must remove the offset errors. There are many basic circuit designs that is used to remove the offset errors. This circuit uses three method to remove the offsets errors, they are symmetrical offset trim, asymmetrical offset trim and amplifier gain adjustment. Here is the circuit: [...]
Read the rest of this article [..]

Notch filter is known as band-cut filter or band-reject filter. The fuction of this filter is to remove some frequency portion of a signal. The schematic diagram of this filter circuit, a second order notch filter is depicted in the figure below. The formula is actually complicated, but by taking the R3=R4 and [...]
Read the rest of this article [..]

The excellent high input impedance, high slew rate, and high voltage qualities of CA3140 op-amp make it suitable for Wien-bridge sine wave oscillator. The basic circuit for Wien-bridge sine wave oscillator is shown in the figure below (the upper part). You can see the formula in the figure, when R1=R2=R, and C1=C2=C, then the formula [...]
Read the rest of this article [..]