Free Circuit Diagram

Water level controller circuit described here control the water level inside a tank. There two modes available with this water level controller circuit. The first mode is empty mode, when the controller will drain the tank if the water level reach the upper limit, the pump will be used to suck the water from the [...]

For any electrically conductive liquid level measurement, this single chip circuit is very compact and simple. This circuit is an ac excited fluid level sensor, which uses alternating current to provide biasing for the sensor probe to avoid electrolysis of the probes.  This ac excitation makes the sensing probe has longer lifetime. This circuit can [...]

Electrolysis process has been the primary cause of your water level detector probes, and you can avoid this by sensing the current by this probe using alternating current. In alternating current, the electrolysis process will be reversed for every alternating cycles, making the probe will last longer to survive from corrosion. The electronic circuit for [...]

For the best advantage as a low noise high input impedance device, the preamp and tone control uses JFET. If the circuit reaches harmonic distortion levels of less than 0.05% with a S/N ratio of over 85 dB, all device parameters are non-critical. 18 dB of cut and boost is allowed by the tone controls. [...]

Our reader Andrea (andrea[dot]perugia[-at-]gmail[dot] com) sent his circuit to us, and he creates the circuit for educational intent. The main purpose is to show that you can toggle an output state electronically, although physically you use only a push button switch. Here is what he said about the cicuit : This simple [...]

Feedback in public address amplifier is something that should be avoided. The ideal solution is by adjusting the microphone and the speaker position, but it’s not always possible in many situation. Using frequency shifter to change the output frequency 10Hz lower than the input frequency can solve the problem, but it’s too expensive for [...]