Posts Tagged ‘Water Level Sensor’
Water Level Indicator with Alarm

This is a Water Level Indicator with alarm circuit. This circuit is used to indicate the amount of water present in the overhead tank. Not only that, but this circuit also gives an alarm when the tank is full. CD4066 is used to indicate the level of the water through LEDs. Here is the schematic …[Read More]
Water Level Controller

Water level controller circuit described here control the water level inside a tank. There two modes available with this water level controller circuit. The first mode is empty mode, when the controller will drain the tank if the water level reach the upper limit, the pump will be used to suck the water from the …[Read More]

For any electrically conductive liquid level measurement, this single chip circuit is very compact and simple. This circuit is an ac excited fluid level sensor, which uses alternating current to provide biasing for the sensor probe to avoid electrolysis of the probes. This ac excitation makes the sensing probe has longer lifetime. This circuit can …[Read More]
Avoiding Electrolysis For Water Level Detector Probes Using Alternating Current Detection

Electrolysis process has been the primary cause of your water level detector probes, and you can avoid this by sensing the current by this probe using alternating current. In alternating current, the electrolysis process will be reversed for every alternating cycles, making the probe will last longer to survive from corrosion. The electronic circuit for …[Read More]
| 

