The DC to AC inverter circuit shown in the schematic here is very simple circuit since it produce square wave, but it’s enough to power many devices. Here is the schematic diagram of the inverter circuit:
The MOSFET is configured as bridge, so the current will flow alternatively in through the primary windings of the transformer. The most expensive part of this dc-ac inverter circuit is the transformer, since it must handle high current up to 10 Amps. You can power any device up to 120 Watts using this 12V inverter circuit.
Possibly Related Articles:
- Small DC-DC Inverter: Convert 1.5 to 9 volts
This is a 1.5 to 9 volts inverter schematic circuit. This is low cost and a simple circuit that need few components.This circuit is used in many application that requires... - 220V Power Line Interface
This is a simple 220V power interface circuit. This circuit used as interface for monitoring electric devices and equipments using a computer. The circuit only senses whether the device being... - Black Light (UV Tube Lamp) Inverter
The voltage boosting in this circuit enable its operation to be powered by 2.5 V rechargeable battery (two cells 1.2V rechargeable batteries), supplying 400 mA current at 26 V which... - Negative Supply From Single Positive Suply Using CMOS Inverter
If only a 5 volt positive supply is available and you need a negative voltage for op-amp or other biasing purpose, the you can generate the negative supply from the... - Simple Theremin with Inverter Gates
This simple but complete Theremin circuit is constructed using only two inverter chip plus one regulator IC. This Theremin circuit consist of five functional blocks: power supply regulator, hand controlled... - Phase Selector (Flipper/Inverter)
Using circuit shown below, we can invert or amplify without inversion by flipping a switch. The voltage gain is depending on the switch position. It could be either +1 or... - Simple PWM Circuit Using Inverter Gates
This PWM circuit needs only two inverter gates, so you can build up to 3 independent PWM circuit using only one IC chip, since there are at keast 6 inverter... - Phase-Shift Oscillator with Inverter Gates
The following circuit diagram show us another kind of CMOS oscillator. It’s will always oscillate because its a loop of three inverters. It would oscillate at a very high frequency... - Complement Phase Inverter with Single Transistor
This is a complement phase inverter circuit. Sometimes this circuit called a paraphase amplifier circuit. This circuit has two output signals that is have sufficient “headroom” because this circuit is... - Simple Toggle Touch Switch Using Two Inverter Gates
We can make a simple touch switch using only two inverter gates, two resistors, and two capacitors. The schematic diagram of the circuit is shown in the figure below. At... - 5V FET Voltage Regulator
This voltage regulator circuit gives a stable 5V output from unregulated inputs (more than 5V). The stability of the output voltage is good enough, only change less than 0.1 volts... - Over/Under Voltage Monitor
This is a over/under voltage monitor circuit. This circuit is used to monitor Any potential from 1 to 15 V. If there is a undesirable variation was occurs, two lamps...
| 
