This is an audio line driver circuit using a TSH22. The advantages of this circuit are low distortion, exhibits a wide bandwidth and an output current sufficient to drive medium impedance loads at a high level modulation. Here is the circuit :
This circuit uses two TSH22 that is used in non inverting mode. The gain of this cricuit can be set by resistors. This circuit only uses a single power supply with voltage between 8V and 30V. A phantom ground at Vcc/2 is made by two resistors (R4 and R6).
Following equations show the overall gain for frequency in the bandwidth :
Gain channel 1 = (R1 + R2)/R1
Gain channel 2 = (R8 + R9)/R8
[Source: STMicroelectronics Application Note]
Possibly Related Articles:
- Low Noise Audio Line driver
LT1206 has been naturally selected as the components for video application since it has suitable bandwidth and output derive capability. This high performance features is not only suitable for video... - Analog Audio Delay Line: Expand Your Virtual 3D Sound Space
It is fun to make a variable space in your small room, but it’s hard to make the actuator to move your wall or room partition. Using analog audio line... - Video Line Driver
LT1206 is suitable for driving multiple video cables since it has 60MHz bandwidth, 250mA output current capability, and low output impedance. Please keep in mind about unterminated line effect when... - RS232 Line Driver Power Supply
This is a RS232 Line Driver Power Supply circuit. This circuit can gives an output of ± 12V at ± 40 mA and only requires an input voltage as low... - Audio Power Meter: Shows Your Audio Amplifier’s Actual Output Power
Using this circuit, you can measure the actual output power of your amplifier. You can put this circuit in a box as a measurement instrument, or you can integrate it...
| 
