This is a intake air temperature (IAT) sensor video. This video shows how the IAT sensor works. This sensor has two terminal, the ground terminal and reference voltage terminal. The ground is connected to the pin 5 of OBD-2 and the 5V refence signal is supplied by ECM. This sensor is maybe located in intake air deck. Here is the tutorial video:
To test this sensor, connect the black probe of the multimeter to the ground terminal and red probe to the positive of battery. The voltage should be 12 V. Then connect the black probe of the multimeter to negative battery and the red one to the signal reference terminal. The voltage should be close to 5V (4.6V to 5V).
Possibly Related Articles:
- EGR Temperature Sensor – Video Tutorial
This is a EGR valve temperature sensor video. This video describe how the EGR valve temperature sensor works. The EGR gasses temperature sensor works like the coolant temperature sensor. The... - Engine Coolant Temperature Sensor – Video Tutorial
This is a video of the engine coolant temperature (ECT) sensor. This video explains how the ECT sensor works. As the temperature goes up, the voltage goes down. Only two... - Testing Diodes in Circuits – Video Tutorial
This is video about diodes in circuits and testing them. In this video, the diodes is tested in two ways, using simple circuit and using multimeter. The diodes in this... - Capacitors Testing Part 2 – Video Tutorial
This is a testing capacitors video tutorial part 2. This Video shows how to check the leakage of the capacitors, the capacity of the capacitors and the breakdown voltage. In... - Capacitors Testing Part 1 – Video Tutorial
This is a tutorial video of testing capacitors part 1. This video shows how to check the capacitors especially for old capacitors. In this video, the capacitors is checked by... - O2 or Oxygen Sensor Heater – Video Tutorial
Below is video tutorial about O2 or Oxygen sensor heater. On the Oxygen sensor, there are two wire with the same color. One color for O2 heater (+) and the... - Automotive Knock Sensor – Video Tutorial
Below is video tutorial about automotive knock sensor. A knock sensor is basically a microphone connected to the engine block. This sensor is tuned in specific frequency. There’s a crystal... - Ping Ultrasonic Sensor – Video Tutorial
This a video about ping ultrasonic sensor. This video shows how to uses a ultrasonic sensor with Arduino microcontroller. The ping ultrasonic sensor is a sensor for measuring distance. This... - Development Kit for Wireless Sensor – Video Tutorial
The wireless technology is developed well today’s. This video is about the wireless sensor development kit. This video explains the wireless sensor from jennic, jennic 5139. This module include microcontroller,... - Hall Effect WSS/Wheel Speed Sensor – Video Tutorial
This video tutorial is about the hall effect WSS sensor. This video describes about how the hall effect sensor work. The wheel speed sensor uses the WSS family. Hall effect... - IR-Linked Temperature Sensor
This is a circuit that transmits temperature data over an IR link and it allows the isolation of temperature sensor. It is a good solution of obtaining temperature readings from... - Isolated Temperature Sensor
In some temperature-sensing applications there are some problems caused by the placement of sensors on location where the potential is very different from that of the data-acquisition-system common. So the...
| 
