Free electronic circuit design and schematic diagram
This is a circuit of Closed-Loop Automatic Power Control for RF Applications. The circuit uses a log detector (AD8318) and a VGA (ADL5330). This circuit has a high temperature stability because of the high temperature stability of the AD8318. The AD8318 also ensures the same level of temperature stability at the output of the ADL5330 VGA. The ADL5330 is converted […]
Read more
This is a circuit of RC5 Infrared Remote Control Transmitter. This circuit uses The PCA8521 that when a key pressed, the PCA8521 generates It generates output pulses, in accordance with the RC5 protocol. Although the IC doesn’t contain a software programmable processor, it contain a ROM which can be used to store the codes that have to be transmitted. Here […]
Read more
This is a infrared Remote Control Decoder circuit. This circuit uses the SAA3049A which is used to check and convert the received coded data (RECS80/RC5) into latched binary outputs. We can uses several device in one location because the device address can be hard-wired for a particular address. The output of this device are the received data and address. Here […]
Read more
The photodiode can be used to detect IR reflected from the object. However, IR produced by the ambient conditions also detected by the photodiode. This IR noise must be filtered to prevent false detections. Usually, the LED’s IR signal is modulated with a convenient frequency and then using that modulation to detect only IR to filter the IR noise. So, […]
Read more
The best choice for stability and high accuracy in temperature measurements is Platinum resistance temperature detectors (RTD). However, the signal conditioning is complicated by the RTD which exhibit a non-linear temperature versus resistance characteristic. The non-linearity amount of 0 C to 100 C is up to 0.4 C. Here is the schematic diagram of linearized platinum RTD signal conditioner : […]
Read moreThis video shows how to having fun using the relay. This video talks about how to make buzzer using relay. The pin configuration of the relay is shown in this video. In this video, the relay that is used is standard 24V relay. When the power is applied on the relay, the relay will buzz. The frequency of the relay […]
Read moreThis is a relay and contactors basics video tutorial. This video shows how relay and contactors work. The relay is an electromechanical switch it works an electromagnet. There are three electrical connection on relay, they are common, normally close and normally open. There is a small contactor inside relay. Besides that, inside relay there is a coil. The coil can […]
Read more