Free electronic circuit design and schematic diagram
This is a circuit of Power-Fail and Low-Line Signals. This circuit is used to warn the processor when the power failure or a brownout is occurs. The processor will enter a power-down routine, when either of those signals interrupts the processor. Back up important data prior to the POR placing the processor in reset and cease its current activities are […]
Read moreThis video tutorial is about servo motor that controlled by PWM signal. There should be two electrical input, one for the power and another for the control signal (to command a position). This servo motor is very common that can be found in the radio control cars and airplanes. The position of the servo motor is related with the width […]
Read moreThis is a video tutorial about breadboard. This video shows how to make a simple circuit on the breadboard. In this video, the circuit that is build on the breadboard is a simple LED light circuit. It require a LED light, a resistor and two cable. Here is the video : The breadboard consist of small holes and some connector […]
Read moreThis is a video tutorial about RJ45. This video shows how to punch down an RJ45 keystone jack using a impact tool. The first thing that we gonna do is strip the wire. It is very important because when we connect the wire, it can cause the problem. And then, put the wire on RJ45, after that punch it down […]
Read moreThis is a video tutorial about multimeter. This video shows how to use a multimeter. The multimeter can be used to measure voltage, current, resistance, etc. The multimeter that is used in this video is a digital multimeter. First thing that must be done before use the multimeter is calibrate the multimeter by connecting each probe. Here is the video […]
Read moreThis is a video tutorial of desoldering. This video shows the technique of desoldering the IC. The wrong technique will cause the overheating to the IC. There are two thing that are required to desolder the IC, they are solder and solder sucker. That would be easy if we use the solder in the left hand and the solder sucker […]
Read more
The diode-OR connection is the simplest link between backup battery and a main supply with a load. But, when the battery voltage is greater than main supply voltage, it will not work. To solve this problem we can use the circuit below. Here is the circuit : This circuit has the backup supply of 9V battery and main switch-mode supply […]
Read more