Free electronic circuit design and schematic diagram
This amplifier circuit combines the LT1010 and a fast discrete stage with an LT1008 based dc stabilizing loop. A differential stage which is single-ends into the LT1010 is formed by Q1 and Q2. An output of 1 V pk-pk into a typical 75-Ω video load is delivered by the circuit. With gain = 2, the gain is considered flat up […]
Read more
An oscilloscope amplifier with 20 dB voltage gain is provided by this circuit with a frequency range from 0.5 to 50 MHz. By increasing the value of the 0.05 uF capacitor or try removing the capacitor, we can extend the low frequency response of this circuit. A particularly small level of input noise is delivered by this circuit, measured at […]
Read more
This regulator circuit stabilize the output voltage at 200V directly (without a transformer). Although the output voltage is high, this circuit only suffer a tension of the voltage drop (Vinput-Voutput), which is suffered mainly by the transistors. The op-amp suffers even less tension, since it regulate the applied voltage at their pins around the level of transistor’s bias voltage level. […]
Read more
This circuit is high voltage regulator which has foldback current limiter protection. This circuit uses LM10 comparator with voltage reference, and this core integrated circuit is connected directly to high voltage circuitry. This high voltage direct connection is possible since the IC is inserted to a bias network and directly drop the applied voltage, so this IC is only suffering […]
Read moreBelow is video tutorial about a noise of a non-inverting operational amplifier circuit. On this video, we are explained about how to calculate the noise of a non inverting amplifier. What we have to do first is ground all the voltage sources. Because now all voltage sources is grounded, so the noise of non inverting configuration is exactly the same […]
Read more
When the resistance value of a temperature, light, pressure, or any other resistive sensors Rs drops below a certain point (adjusted by a preset potentiometer), the SCR (silicon controlled switch) will be triggered. The sensor (Rs) and the potentiometer placement can be interchanged to get opposite action, where the SCR need to be triggered at the increase of sensing resistor […]
Read more
Astable multivibrator or oscillator circuit is based on positive feedback. We can design such circuit using op-amp, logic gates, or transistors. Here we can rely on single capacitor capacitor and resistor for the feedback inside op-amp like transistor circuit, which works over wide range of temperature, voltages and transistor gains. The stability is pretty good, for supply voltage changes between […]
Read more