Free electronic circuit design and schematic diagram
This bench power supply circuit is suitable for your electronic experiment lab. This circuit can be built no on a piece of copper-laminate. The Bench Power Supply was designed to use old lantern batteries, “D”, and “C”. This circuit can produce at least 12v -14v from old batteries and cells. As a heat-sink, this circuit uses a board. To connect […]
Read more
This is simple 2N3055 Variable power supply circuit. This circuit has some advantages such as it it can deliver an output voltage between 1,5 V and 15 V with a 500 mA maximum current and low production cost. If the current consumption do not exceed 350 mA, the circuit has stabilization of better than 2%. Here is the circuit: The […]
Read moreTypical circuit for welding equipment shown on the following circuit diagram. Turn on delay can be controlled accurately with Potentiometer P2. We can discharge C1 at each line zero voltage using DB1 diode bridge and R6-R7 resistors. The voltage charge will be reset at each new half line cycle and the turn-on delay will be maintained the same. Through both […]
Read more
The first thing you must have in your workshop/lab is power supply. In experimenting many new electronic circuit design, it is easier if you have a flexible adjustable power supply. Here is an adjustable 0-30 volts power supply design. The circuit schematic diagram is shown below. The core of the circuit is 723 voltage regulator integrated circuit. A Darlington pair […]
Read more