Free electronic circuit design and schematic diagram
Standing wave ratio(SWR) is a ratio of amplitude of partial standing wave at maximum to amplitude at minimum. Using a Simple Swr Bridge circuit, a SWR can be measured. This circuit give a balanced VSWR meter perfectly, so adjustment is not required. This circuit can be made from a coupler which formed by a 6.5-inch piece of RG-58A/U coax. Here […]
Read more
This is a Single-cell microphone amplifier circuit. This circuit produce a voltage gain of 60 dB at 500Ω load with bandwidth 5kHz. This circuit can provide a 60dB gain up to 10kHz if it is unloaded. This circuit has a 10 kΩ input impedance. This circuit cannot neither produce an output swing closer than 800mV or below 150mV to the […]
Read more
This is a Frequency Difference Measurement circuit. This circuit consist of two TC9400 that is configured in the F/V mode. So, the TC9400 will convert both frequencies into proportional analog voltage(V1 and V2). This circuit also uses unity gain inverter to invert V2. After that, this circuit will add the V1 and -V2 using the summing op-amp. That operation will […]
Read more
This circuit is a Delayed Pulse Generator that is used to provide pulse rate and independent control of initial delay. The pulse generator of this circuit is IC1c which the operation is depended on the normally low O/P of the IC1a. The PB1 is used to make the circuit input goes low. When PB1 is pressed, IC1b O/P goes high […]
Read moreThis is a video of EMI/RFI filters. This video explains about electromagnetic filters and radio frequency filters. This video also describe about consequence of the filter that is implemented on the susceptible system. The information of insertion loss and electrical characteristics of EMI/RFI filters are shown on this video. The example of EMI/RFI filters are powerline filter, power entry modules, […]
Read more
If the sensor system need an active supply, we can use only a single pair of cable to carry both the power supply and the output signal. Not only simplify the wiring, converting analog voltage level to frequency modulated pulse improve the noise immunity as well. Here is the schematic diagram of the system: The diode is employed to prevent […]
Read more
This is a Electrostatic transducer for ultrasonic measurement circuit. This circuit uses the LM1812 ultrasonic transceiver. Transducer x1 and LM1812 will transmit a burst of oscillations. Then the return echo is listened by using X1. The LM1812 detector will generate a pulse of the same width as the original burst when the X1 receive an echo of sufficient amplitude. If […]
Read more