Free electronic circuit design and schematic diagram
This is a circuit of board system monitoring for temperature and voltage condition. It uses the NE1617A. The NE1617A is a 2 channel temperature sensor. It can measure remote and internal sensor. It also supports up to nine devices per bus. The temperature data update is selectable from 125 ms to 16 seconds, if it is used in normal operation. […]
Read more
This is a circuit of SA58672 Small Class-D Audio Amplifier. This circuit is suitable for mobile device. It has maximum output power of 3.0 W for a 4ohm load and 1.7W for 8ohm load with power supply of 5V. If we uses 3.6 V power supply, the maximum output power is 900mW with 8ohm load. Here is the circuit : […]
Read more
This is a circuit of Power-Fail and Low-Line Signals. This circuit is used to warn the processor when the power failure or a brownout is occurs. The processor will enter a power-down routine, when either of those signals interrupts the processor. Back up important data prior to the POR placing the processor in reset and cease its current activities are […]
Read moreThis video tutorial is about servo motor that controlled by PWM signal. There should be two electrical input, one for the power and another for the control signal (to command a position). This servo motor is very common that can be found in the radio control cars and airplanes. The position of the servo motor is related with the width […]
Read moreThe configuration in the circuit diagram below can be used when a slow rise time of the output voltage is required. We can find the rise time with following formula: ton= CVoR 0.45 Capacitor C is discharged when the switch position is ON and this will maintain the voltage at pin 2 low. The Vo follows the voltage at pin […]
Read more
It’s good to reduce the power dissipated by the device. Using resistor connected in series to the input (the left figure) is a simple and economic method to reduce the device input-output differential voltage. Here’s the formula for calculating R: R= [Vi min- (Vo+Vdrop)]/Io Vdrop = minimum differential voltage between the input and the output of the device at current […]
Read more
The TPS61160/1 is a boost converter that drives up to 10 LEDs in series with a 40-V rated integrated switch FET. To reduce output ripple, improve convertion efficiency, and allows for the use of small external component, the boost converter is very usefull. The default white LED current is set with the external sensor resistor Rset, and the feedback voltage […]
Read more