This switch mode regulator circuit has higher current output than our previous switch mode regulator, but it uses same controller IC. Up to 10A can be served by this switch mode regulator. The output of this regulator circuit is regulated at 3.3 volt, and the input range is 4-9Volt.
The SHDN pin can be pulled high (CMOS level) to shut down the operation, shut the current down to 50uA or less. This SHDN pin must not left unconnected, shoud be connected to ground for normal operation or conncted to 1.5V or more potential to shut down the operation, you can do this by hard wiring, switch, or CMOS logic. To optimize efficiency, this switch mode regulator automatically switches between two modes of operation, burst and continuous, and this automatic setting require the BINH pin to be grounded. When you want the burst mode to be disabled, you shoud connect this BINH pin to the voltage input supply. [Circuit's schematic diagram source: Linear Technology Application Notes]
Possibly Related Articles:
- High Efficiency Switch Mode 3.3V 5A Step-Down Converter
This switch mode step-down converter has very good efficiency, up to 94% can be obtained. This switch mode regulator uses LTC1266-3.3 controller with external N-Channel power mosfet, and need only... - Transformerless, Switch Mode Boost Regulator, A Step-Up Converter
Using this switch mode regulator circuit, you can get a stable 12 volt output (500mA) although you just have 4,3 – 10V power supply. You can even boost a 3.5V... - Variable Frequency Switch Mode Regulator
This voltage regulator circuit operates in switch mode. Using the configuration shown in the schematic diagram, this circuit has variable switching frequency, depends on the input voltage and load condition.... - Very High Efficiency Solar Powered Motor Driver
This motor driver circuit control the charging and power delivery cycles to enable small solar cell to drive dc motor. Here is the schematic diagram of the circuit: You have... - Constant Current Constant Voltage SMPS (Switch Mode Power Supply)
This constant current constant voltage SMPS can be used to efficiently charge a battery. This circuit gives 7.2V at constant voltage mode, and 600 mA at constant current mode. Here... - Switch Mode Lead Acid Battery Charger
More efficient lead acid battery charger can be implemented using switch mode circuit. A switch mode for lead acid battery charger can be constructed using bq24105 battery charger controller. The... - Direct High Voltage DC Regulator
This regulator circuit stabilize the output voltage at 200V directly (without a transformer). Although the output voltage is high, this circuit only suffer a tension of the voltage drop (Vinput-Voutput),... - Foldback Current Limited High Voltage Regulator
This circuit is high voltage regulator which has foldback current limiter protection. This circuit uses LM10 comparator with voltage reference, and this core integrated circuit is connected directly to high... - 5V FET Voltage Regulator
This voltage regulator circuit gives a stable 5V output from unregulated inputs (more than 5V). The stability of the output voltage is good enough, only change less than 0.1 volts... - LM2576 Switching Regulator
The circuits. To produce any output voltage, an external feedback resistors can be added. The sLM2576 is a Switching Regulator that can produce 15, 12, 5, 0r 3.3V output voltage... - Discrete Voltage Regulator
It is still possible to build circuits without IC’s and still achieve a high level of performance while integrated circuits have become a staple of all modern circuit designs. A... - Adjustable Shunt Regulator
This shunt regulator acts like a Zener diode, but we can adjust the voltage (via a potentiometer). Here is the schematic diagram of the circuit: When the maximum load current...
| 
