Below is reverse engineered circuit diagram of yet another commercially produced solar garden lamp. To turn the light on at night, this depends upon a CDS photocell. It allows the battery to charge more efficiently although more complex than the circuits.
Read more original source:
http://members.shaw.ca/novotill/SolarGardenLight/index.htm
Possibly Related Articles:
- Audio-Controlled Incandescent Lamp Light Controller
This is a audio-controlled lamp circuit. This circuit requires low voltage input such as pre-amplifiers, tone control, or general audio line level output. It’s also possible to feed the input... - Black Light (UV Tube Lamp) Inverter
The voltage boosting in this circuit enable its operation to be powered by 2.5 V rechargeable battery (two cells 1.2V rechargeable batteries), supplying 400 mA current at 26 V which... - Strobo Disco Light Using Standard Tube Lamp (TL)
Using a standard fluorescent tube lamp (TL), you can make your own disco light, similar to a stroboscope light. You can even use a half-broken lamp, which one side of... - Very High Efficiency Solar Powered Motor Driver
This motor driver circuit control the charging and power delivery cycles to enable small solar cell to drive dc motor. Here is the schematic diagram of the circuit: You have... - High Efficency Solar Powered Motor Driver
This motor driver deliver the power form capacitor to the motor when the capacitor is charged to 1.75V by the solar cell. After powering the motor, capacitor voltage will be... - AC Powered-LED Flasher
Based on a request by FreeCircuitDiagram reader Helynn Schufletowski, here we present an AC powered-LED flasher circuit for all of you! DEADLY ELECTRICAL SHOCK WARNING: This circuit is not isolated... - AC Powered-LED Circuit
The high durability nature of a light emitting diode (LED) make it suitable for ON/OFF indicator application. Because the limitation on low operating voltage, LEDs are normally applied on low... - 10-20V Regulated LED Lamp
Resistor and LM317L act as a current regulator set to 40 ma. Current will flow from the battery through one pair of LEDs, and then to the regulator, through the... - 12V Fluorescent Lamp Circuit
Fluorescent lamp or tube lamp (TL) has good efficiency. This high efficiency feature make it suitable for battery operated lighting application. To drive the tube lamp, we need high voltage... - Sound-Activated Lamp (Relay/Switch)
This simple circuit shown int the schematic diagram actives the switch using sound. We can use this circuit for various applications, such as automatic (sound-controlled) disco light or car’s LED... - IR2156 Electronic Ballast for CFL (Compact Fluorescent Lamp)
This is Electronic Ballast for CFL (Compact Fluorescent Lamp) circuit using IR2156. The IR2156 contains a high voltage half-bridge gate driver with a state diagram and programmable oscillator to make... - Switchstart Ballast Circuit for Fluorescent Tube Lamp
Simplicity, low cost and improved efficiency when compared with the alternative options are the reasons why the switchstart circuit has been widely adopted. Moreover, the 230V mains voltage is sufficiently...
| 
