This amplifier has VHF (very high frequency) and UHF (ultra high frequency) response, you can use it for receiver booster for example. Here is the schematic diagram of the circuit:
The current consumption is very low, under 20 mA for 14V voltage supply. Lower current consumption can be achieved if we use 10V power supply, the current consumption would be under 14 mA. [Circuit's schematic diagram source: lh-electric.4t.com]
Possibly Related Articles:
- UHF Antenna Booster
UHF antenna booster can be used for better reception, especially when you’re far from TV station / relay transmitter. This UHF antenna booster works in 400-850 MHz range. Here is... - AM/FM Antenna Booster
This antenna booster circuit can be used to amplify the weak signal received by the antenna. Antenna for AM/FM is usually not tuned for the optimal dimension of 1/4 wavelength,... - Active Antenna With Gain (Booster)
This is an active antenna circuit with gain. This circuit is used to bost the signal. This circuit is made from a few transistors and other components. This circuit can... - How to Pre-Tune a Ham Radio Antenna – Video Tutorial
This is video about how to pretune a ham radio antenna. This video shows how to tune a ham radio. In this video, the antenna is tuned to make sure... - Stereo VU Booster Circuit using Transistors
This is a Stereo VU Booster circuit. In this circuit, shown in the schematic diagram, transistor FCS9014 is used. Actually you can use almost any type of small signal NPN...
| 
