Free electronic circuit design and schematic diagram
FM demodulation can be done with phase locked loop (PLL), and this method is common in high-end communication system. This system uses TC9400 that has high linearity. Using TC9400, the performance of phase-locked loop will increases greatly. That will give very precise tracking of Vout with respect to Fin. Here is the block diagram of the FM demodulation with a […]
Read more
Another application of FVC (frequency-to-voltage converter) is tone/frequency decoder. This circuit is used to determine the frequency band of an oscillation signal. This circuit is used in many application like determines the frequency band in the signal and remote control where the frequency band corresponds to a different command. This circuit uses TC9400 F/V converter to convert the frequency to […]
Read more
This is a schematic diagram of Permanent Magnet Motor Control circuit. This circuit is used to control the permanent magnet control. This circuit uses alternistor triac to enhance commutation characteristics because the PM motor is a generator where the standard triac difficult to commutate properly. The full-wave DC rectification is needed for PM motors. Here is the schematic diagram of […]
Read more
This is a Reduced Hysteresis Diac-Triac Phase/Power Control circuit. This circuit is used to control from 5% to 95% of full load power. This circuit can decrease the hysteresis effect to a reasonable region. It can be done because this circuit uses second RC phase-shift network. Beside that, the second RC phase-shift network also extends the range on control. This […]
Read more
Hysteresis in lamp dimmer or in other electric appliance might cause some trouble if you need a fine tuning, something like out of control. This is a circuit of Diac-Triac Phase/Power Control without Hysteresis. This circuit can eliminate the hysteresis effect. Here is the circuit: The initial condition of the timing capacitor is uniform because the (a) circuit reset timing […]
Read more
This is a Overvoltage Protected 5V Power Supply circuit. This circuit can be used to supply 74LS series integrated circuit and TTL. This circuit can protect the TTL or 74Ls series integrated circuit from damage because these ICs are easily damaged by short voltage spikes. This circuit uses a fuse which if the current rating is exceeded, the fuse will […]
Read more
This is a 3 Band Equalizer circuit. This circuit is made to control the treble, middle and bass range. This circuit uses a single op-amp. With single op-amp we can build equalizer which has three ranges, high frequency, mid frequency, and low frequency. Here is the schematic diagram of the circuit: This circuit has a cut off frequencies of 10kHz, […]
Read more